Tailoring Class Note

Parts of a Basic Sewing Machine and Their Functions It is important for the beginner to know and recognize the

1.Put the piness foot in the ascendant pun Place a reel of the on the spool holder Hoving from the

Common Sewing Machine Problems and their Solutions Different Hand Sewing Methods Every tailor should know a few of the basic

Unit Objectives At the end of this unit, you will be able to 1 Recognize the different parts of a

Step 1: Take the fused j-fly piece and put overlock stitch on the face side of the fabric starting from

Step 1: Take both the left and right back pieces. Match them face- to- face. Step 2: Put 1 cm

Step 1: Fold the bottom of right trouser leg 1 cm inside Again fold the fabric to the required width

Step 1: Take the fused pocket piece. Step 2: Locate the notch marks. Step 3: Now fold the top part

Step 1: Take the two sleeve pieces and identify the notch marks on the armhole side in each one of

Step 1: Match the armhole and align the loose ends. Step 2 : Take the right hand sleeve Stitch 1

Collar and Neckband Preparation Step 1: Take the fused neckband piece. Turn the bottomend of the piece  with your hand.

Cuff Attachment to Sleeve Step 1: First, check that there are 4 notches for sleeve plesatsand one notch at the

Measurements needed .Chest .Full length of the blouse .Shoulder .Sleeve length .Sleeve round . Front length-Measured from shoulder along the

STEP 1: Take 2 Pieces of Kameez (Front and Back) 2 Pieces of Sleeve (Right and Left) and 2 rectangular

Buttons: The various types of buttons available in the market differ in that they have different number of holes-2 or

Unit Objectives At the end of this unit, you will be able to: 1.Understand flat stitches, loop stitches and knotted

Loop stitch gets its name from the long loops it leaves behind Commonly used types of Loop Stitches and their

Unit Objectives At the end of this unit, you will be able to: 1 Know the importance of basic elements

Why and How to Fit? To have a good fit of a garment, accurate calculations and design corrections is not